User Tools

Site Tools


new_hid_controller

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
new_hid_controller [2020/01/29 10:55]
jlester
new_hid_controller [2020/01/29 11:02] (current)
jlester [Install Badge Reader and Door Controller]
Line 59: Line 59:
   - Snap the terminal blocks onto the door controller and install it to the mounting plate. ​ There'​s a ridge on the top that it goes over first and then swings down flush so you can put the screw through it and into the mounting plate.   - Snap the terminal blocks onto the door controller and install it to the mounting plate. ​ There'​s a ridge on the top that it goes over first and then swings down flush so you can put the screw through it and into the mounting plate.
   - Plug up the network cable. ​ You should hear it beep a couple of times as it is booting up.   - Plug up the network cable. ​ You should hear it beep a couple of times as it is booting up.
 +  - Check the door to ensure it is locked while the controller is booting up.
  
 ===== SimpleID Setup ===== ===== SimpleID Setup =====
new_hid_controller.txt · Last modified: 2020/01/29 11:02 by jlester